They are suitable for transferring liquids containing impurities up to 3 mm in size.
Their hydraulic components: impeller in brass, feed screw and pump body in aluminium allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel).
The temperature of the liquid must not exceed 90°C.
They are commonly used on:
- machine tools (milling and turning machines-machining centres)
- filtration systems
They are normally installed on a tank with a capacity which is proportional to their flow rate, about 4-5 cm from the bottom.
It is important to make sure that the maximum liquid level in the tank is always 3-4 cm lower than the support flange.
Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.
Products:
AREM code |
Pump model |
Input kW. |
Height of suction mm |
1607301 | MP 63C | 0,55 | 180 |
1607302 | MP 63C | 0,55 | 230 |
1607303 | MP 63C | 0,55 | 280 |
1607304 | MP 63C | 0,55 | 330 |
1607305 | MP 71A | 0,75 | 180 |
1607306 | MP 71A | 0,75 | 230 |
1607307 | MP 71A | 0,75 | 280 |
1607308 | MP 71A | 0,75 | 330 |
1607309 | MP 71B | 0,90 | 210 |
1607310 | MP 71B | 0,90 | 260 |
1607311 | MP 71B | 0,90 | 310 |
1607312 | MP 71B | 0,90 | 360 |
1607313 | MP 80C | 1,50 | 230 |
1607314 | MP 80C | 1,50 | 280 |
1607315 | MP 80C | 1,50 | 355 |
1607316 | MP 80C | 1,50 | 470 |
1607317 | MP 90B | 3,00 | 265 |
1607318 | MP 90B | 3,00 | 315 |
1607319 | MP 90B | 3,00 | 390 |
1607320 | MP 90B | 3,00 | 505 |
1607321 | MP 100B | 4,00 | 265 |
1607322 | MP 100B | 4,00 | 315 |
1607323 | MP 100B | 4,00 | 365 |
1607324 | MP 100B | 4,00 | 415 |
1607325 | MP 100B | 4,00 | 595 |